Yup its mainly for moving files quicker through my network but also helps me in having a redundant network in the case that something fails. This will also enable for you to have one static IP address for all your NIC's.Īlthough If you'd prefer to have different static IP addresses for each NIC then its better that you do not follow the above mentioned steps as you will not be able to set individual IP-addressees for each card. This newly created network adapter can then be used for your VM in Hyper-V also. Also note that the box marked in "red" show the network connection speed of the network adapter. * Do note that I have removed my DNS name and IPv4 & IPv6 address as I do not want to make that info public but if you carry out the same steps as mentioned above you should end up with the same result. Next I checked out the Network Properties of my NIC cards and made sure that "Realtek Teaming Protocol Driver (NDIS 6.40)" was installed.Īfter this was done I executed the above mentioned command in Power Shell which in turn resulted in the creation of my Teamed NIC Adapter to be visible in "Control Panel\Network and Internet\Network Connections".įinally the end result of this was that I was able to create on "Microsoft Network Adapter Multiplexor Driver" Adapter that was able to connect to all my other NIC cards at the same time and hence enabling me to have a solid 3Gb/s internet connection. Since I have a Realteck NIC I first uninstalled the drivers and then reinstalled the NIC's with the latest drivers form Realteck. Unfortunately since I do not have a Intel Network Card this option wast possible for me to test out. + FullyQualifiedErrorId : MI RESULT 1,New-NetLbfoTeamįorm this I understood that LBFO is not supported in "Windows 10 SKU" but only in "Windows Server".Īnother way to enable NIC Teaming could be to use the "Intel Network Connections Application" and enable Teaming. + CategoryInfo : NotSpecified: (MSFT_NetLbfoTeam:root/StandardCimv2/MSFT_NetLbfoTeam) , New-NetLbfoTeam : The LBFO feature is not currently enabled, or LBFO is not supported on this SKU. New-NetLbfoTeam -Name "Team1" -TeamMembers "NIC1","NIC2" -TeamingMode LACPīut wasn't able to implement the NIC teaming within the cards as I would constantly receive the following error: New-NetLbfoTeam -Name "Team1" -TeamMembers "NIC1","NIC2" Previously I tried the following commands: with the name of my NIC's as seen on "Control Panel\Network and Internet\Network Connections". Where I replaced "SwitchTeam01" with a name that refers to the teaming of multiple NIC cards and replaced: "Ethernet", "Ethernet 2" etc. New-NetSwitchTeam -Name "SwitchTeam01" -TeamMembers "Ethernet","Ethernet 2", "Ethernet 3" This command was implemented on a Windows Build (圆4bit). So I was able to enable teaming of multiple NIC cards by typing in the following command in Windows PowerShell.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |